Search
Now showing items 1-10 of 29
Role of fabric reinforcement on the low amplitude oscillating wear of polyetherimide composites
(2004)
Influence of fabric reinforcement in polymers is well investigated in the unidirectional sliding wear mode leading to adhesive wear of the composites, but not in the case of low amplitude oscillating (fretting or reciprocating) ...
Effect of impinging velocity on the erosive wear behaviour of polyamides
(2004)
Various parameters, such as type, size and velocity of erodent and impact angle, are important for the erosive wear behaviour of materials. In this work, the erosive wear behaviour of various polyamides (PAs), viz. PA 6, ...
Friction and wear behavior of polyetherimide composites in various wear modes
(2001)
A high performance engineering polymer, polyetherimide (PEI) and its two composites, one containing only short glass fibers (GF) 20% and the other, commercially established bearing material containing 25% GF and three solid ...
Tribo performance of polyaryletherketone composites
(2002)
The mechanical and tribological properties of various injection-moulded polyaryletherketones (PAEKs) and their
composites are presented in this paper. The mechanical properties studied were tensile strength, tensile modulus, ...
Erosive wear bahavious of various polyamides
(2001)
A series of polyamides (PAs), namely, PA 6, PA 66, PA 66/610, PA 11, PA 12 and aromatic PA (brittle, hard and amorphous) was selected for investigating the effect of chemical structure and hence, mechanical properties on ...
Performance of friction materials based on variation in nature of organic fibres: Part I. Fade and recovery behaviour
(2004)
The loss in braking effectiveness at elevated temperatures and the revival of the same at lower temperatures is referred to as fade and recovery, respectively. These characteristics are of decisive importance in the ...
Wear data analysis of friction materials to investigate the simultaneous influence of operating parameters and compositions
(2004)
The present paper deals with the wear data analysis of friction composites where, the nature and the concentration of the abrasives were varied systematically in steps of 2%. The abrasives selected were; SiC, SiO2, ZrO2 ...
Influence of fibers and solid lubricants on low amplitude oscillating wear of polyetherimide composites
(2004)
The influence of short fiber reinforcement and solid lubricants is widely studied in rotational sliding adhesive wear mode, but not much is reported in low amplitude oscillating wear situation. In this paper a series of ...
Performance of friction materials based on variation in nature of organic fibres: Part II. Optimisation by balancing and ranking using multiple criteria decision model (MCDM)
(2004)
Multiple criteria decision model (MCDM) is used for optimisation of several conflicting criteria dependent systems. A multiple criteria decision model (MCDM) approach taking into account the performance defining attributes ...
High temperature friction and wear characteristics of various coating materials for steam valve spindle application
(2000)
Various coatings such as chromium carbide deposited by plasma spraying and detonation gun techniques , chromium oxide, chromium oxideqtitaniaqsilica, NiCrAlY, and Al O qNiAl, all deposited by plasma spraying; stelliting, ...